The DC single acting solenoid G MC X …B01 is the further development of the model range G MC X.

The main differences compared to DC solenoids are as follows:

• The solenoid body is firmly connected with the solenoid drive, the coil cannot be spun or exchanged
• Fastening by 3 frontal threaded holes
• Size 63 mm has a 15 mm stroke instead of 12 mm
• Pull or push models are available
• Protection class is IP54 for the complete device since the tie bar is sealed. Models with no seal upon request
• The device has an earth conductor so that nominal voltages up until 250VDC are possible.
• For the time being, no types with explosion protection are planned.

Sizes (Ø): 37 mm, 45 mm, 63 mm

• Rising magnetic retention forcestroke curve
• Electrical connection by plug connector according to DIN EN 175301803
• Fastening by 3 frontal threaded holes
• Protection class: IP54
• Voltage type: direct current, DC
• Options: further electrical connections

If you intend to use the device as a locking unit, please also refer to our shot bolt lock units types G SC X ... B01

Parameter Name	Parameter Value
Type	linear
Other characteristics	single-acting 24-volt DC pull push
Voltage (V)	24 - 24
Force (N)	8 - 139
Stroke (mm)	8 - 10