Thin 2-jaw parallel gripper
The thin body enables flexible system design
The high restoration accuracy by utilizing workholding technology of lathe chucks
NPGT achieves higher gripping force than the similar stroke model
Variety of options including several detection methods.

* Air pressure set at 0.6 MPa.
Measurement Distance L(mm): 10
Repeatability(mm): ±0.008
Mass (kg): 0.79
Air Consumption per reciprocating (cm3): 32
Air pressure (MPa): 0.2 ~ 0.8
Operating Temperature (℃): 5 ~ 60

Note 1: Please install a check valve in the air-pressure circuit so that the gripper will not release a workpiece even if the air pressure drops down.
Note 2: When the jaw stroke is detected by the reed switches, mount reed switched on the grooves on the outer periphery of the product.
Note 3: In case proximity switches are used for direct detection of jaw stroke, please purchase proximity switch brackets additionally.
Note 4: The material of internal seals of grippers is nitrile rubber. If the fluororubber seals are needed, please consult Kitagawa distributor.

Parameter Name	Parameter Value
Operation	pneumatic
Type	parallel
Number of jaws	2-jaw
Options	internal
Grip strength (N)	500 - 600
Stroke (mm)	8.3 - 16.6