Interface for the direct connection of two different worlds.

The device consists of a plastic housing with 6 modules, fitted with a plug-type connection (output). It has been conceived for DIN35 rail mounting.

The whole range of Belimo MFT/MFT2 actuators, operated by MP-Bus, can be individually connected to this interface coupler and be integrated to the KNX network. The KNX interface is able to support up to 8 MP actuators - e.g. flap drives, valve drives, regulation ball valve drives or flow rate controllers - intended for building automation. During commissioning the KNX Gateway is configurated with ETS. The requested drive channel is selected and parametrised for the needed drive type. Status indicators and push-buttons for programming the address- and test-functions are located on the front side of the device. There is also a plug intended for the Belimo hand-held parameter assignment device.

Actual and setpoint values, status of the drive and also the values of passive or active sensors connected to the drive are transmitted via KNX.

Parameter Name	Parameter Value
Type	communication
Network	Fieldbus
Other characteristics	multi-protocol